Show simple item record

dc.contributor.authorDurmuş, Ali
dc.contributor.authorGüden, Mustafa
dc.contributor.authorGülçimen, Betül
dc.contributor.authorÜlkü, Sedat
dc.contributor.authorMusa, Eldar
dc.date.accessioned2015-12-08T08:23:35Z
dc.date.available2015-12-08T08:23:35Z
dc.date.issued2011
dc.identifier.citationDurmuş, A., Güden, M., Gülçimen, B. Ülkü, S. & Musa, E. (2011). Experimental investigations on the ballistic impact performances of cold rolled sheet metals, Materials & Design, 32(3), 1356-1366. doi:10.1016/j.matdes.2010.09.016en_US
dc.identifier.urihttp://doi.org/10.1016/j.matdes.2010.09.016
dc.identifier.urihttp://hdl.handle.net/11147/4368
dc.description.abstractThis study focuses on the ballistic performances of 1 and 2 mm-thick and 2 × 1 mm-thick cold rolled sheet metal plates against 9 mm standard NATO projectile. The velocity of the projectile before and after perforation, the diameter of the front face deformation, the depth of the crater and the diameter of the hole were measured. The fracture surfaces of the plates near the ballistic limit were also microscopically analyzed. The highest ballistic limit was found in 2 mm-thick plate (332 m s−1) and the lowest in 1 mm-thick plate (97 m s−1). While, the ballistic limit of 2 × 1 mm-thick plate decreased to 306 m s−1. Typical failure mechanism of the projectile was the flattening and mushrooming at relatively low velocities and the separation from the jacket at relatively high velocities. In accord with the ballistic limits, 2 mm-thick target plate exhibited the highest hardness value. Microscopic investigations showed the significant reductions in the grain size of the targets after the test.en_US
dc.language.isoengen_US
dc.publisherElsevieren_US
dc.relation.isversionof10.1016/j.matdes.2010.09.016en_US
dc.rightsinfo:eu-repo/semantics/openAccessen_US
dc.subjectImpact and ballisticen_US
dc.subjectFilm and sheeten_US
dc.subjectFailure analysisen_US
dc.titleExperimental investigations on the ballistic impact performances of cold rolled sheet metalsen_US
dc.typearticleen_US
dc.contributor.authorIDTR114738en_US
dc.contributor.institutionauthorGüden, Mustafa
dc.relation.journalMaterials & Designen_US
dc.contributor.departmentİYTE, Mühendislik Fakültesi, Makina Mühendisliği Bölümüen_US
dc.identifier.volume32en_US
dc.identifier.issue3en_US
dc.identifier.startpage1356en_US
dc.identifier.endpage1366en_US
dc.identifier.wosWOS:000286904200033
dc.identifier.scopusSCOPUS:2-s2.0-78649905594
dc.relation.publicationcategoryMakale - Uluslararası Hakemli Dergi - Kurum Öğretim Elemanıen_US


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record